Electrical

The scooter works perfectly until I turn the lights on

Started by mossy_glen22 • November 19, 2026 • 10 replies
mossy_glen22
mossy_glen22 November 19, 2026 at 10:55 AM

Hi all, I've got a secondhand Pride Revo that runs fine on flat ground and up small slopes. But as soon as I flick the headlight switch on, the whole thing slows to a crawl and the battery gauge drops two bars. When I turn the lights off, it recovers. I mostly ride in the evenings so the lights are non-negotiable. Has anyone dealt with this? I'm not very handy with electrics.

spanner_jen
spanner_jen November 19, 2026 at 11:04 AM

First thing I'd check is the bulbs. If someone swapped in higher-wattage ones than the circuit is meant for, they'll pull way more current than the harness was designed for and can drag the whole system down. Easy to verify with a multimeter if you have one.

bramblepath
bramblepath November 19, 2026 at 11:23 AM

Two bars is a lot for a couple of bulbs. That sounds like the battery is already weak and the added load is exposing it, rather than the lights causing a new problem. How old is the battery pack and when did it last hold a full charge?

mossy_glen22
mossy_glen22 November 19, 2026 at 11:38 AM

The battery is probably three years old, maybe more. It waz on the scooter when I bought it. It charges up to the green zone overnight though, so I assumed it was okay.

northfield_pete
northfield_pete November 19, 2026 at 12:24 PM

Three years is around when AGM batteries start losing capacity. The gauge can show green aftter a slow charge but the pack can't deliver a burst of current without sagging. Lights make that sag visible.

spanner_jen
spanner_jen November 19, 2026 at 12:33 PM

Could also be a loose ground. If the light circuit shares a ground with the controller, a corroded connection will add resistance only when when current flows. I'd look at the wiring around the front tiller before spending money on a battery.

quiet_hedge
quiet_hedge November 19, 2026 at 12:44 PM

Mine did something similar and it turned out to be a chafed wire inside the tiller housing. Took a while to find. Not saying that's your issue, just that these things can be sneaky.

bramblepath
bramblepath November 19, 2026 at 12:48 PM

If you do replace the battery, don't go bigger than the original spec. A pack with higher amp-hours won't fix a wiring fault and could add weight you don't need.

northfield_pete
northfield_pete November 19, 2026 at 12:52 PM

Agreed on matching the original spec. Also worth checking whether the lights are wired through the controller or on their own fuse. Some older Revo models had the lights on a separate circuit, and a bad fuse holder there can cause odd behaviour without blowing the fuse.

mossy_glen22
mossy_glen22 November 19, 2026 at 12:53 PM

Thanks, that gives me a few things to look at. I'll start with the bulbs and the ground connections before pricing a battery.

spanner_jen
spanner_jen November 19, 2026 at 1:12 PM

Let us know what you find. If the gauge only drops with the lights on, I still think it's the battery sagging under load, buut it's worth ruling out the cheap fixes first. One more thing: if you're testing, do it on a slight incline. That loads the motor just enough to make the problem obvious without being unsafe.

Post a reply

Find Your
Perfect Scooter šŸ”„