The horn stopped working at exactly the same time as the display
Bit of a weird one. My Kymco Agility has been fine for 3 years, but yesterday I turned the key and the display didn't light up. Then I pressed the horn button just out of habit and nothing. Scooter still drives, but no display and no horn. I've checked the main fuse under the seat and it looks OK. Anyone seen this before?
Horn and display on the same circuit? That's unusual. Usually the horn is on its own fuse. Have you checked the little fuses in the tiller? Some models have a separate fuse block up there.
Mine did something similar. Turned out the ignition switch itself was faulty. The contacts had worn so it wasn't sending power to the accessory circuit, but the main drive circuit still worked. Might be worth wiggling The key while it's on.
Thanks, both. I'll have a look at the tiller fuses tomorrow. @coastalpath22 I tried wiggling the key earlier and nothing changed, but I'll give it another go with a bit more force.
Could be the ignition relay. On some scooters the relay feeds both the horn and the display, and if it fails open you get exactly this. Usually a cheap part to replace if you're handy with a spanner.
No help but I'm following this because my horn stopped working last week and I just ignored it. Didn't realise the display might be connected. Now I'm worried.
If it drives fine, it's probably not the battery or the main fuse. Start testing with a multimeter at the horn button. If no voltage there, work backwards through the loom.
@not_a_mechanic don't panic. Horns fail on their own all the time, usually just a corroded connector. The display being out at the same time is what makes this one interesting.
Interesting is one word for it. I'm not great with electrics but I've got a neighbour who'll lend me a multimeter. Will report back if I find anything useful.
Have you recently ridden in heavy rain? Water ingress in the tiller can cause all sorts of odd behaviour. My old Quingo did something very similar after a soaking and dried out fine.
Good point about water. Also check the connector block behind the display. If it's damp, a bit of contact cleaner and a squirt of dielectric grease can sort it.
Also worth checking the earth strap from the chassis to the frame. A bad earth can back-feed through the system and cause weird combos of faults. Happened on a mobility scooter my dad had.
Update on mine: I cleaned the horn connector and it works again. Display was never a problem, so I probably just got lucky. But I'm now treating every electrical gremlin like it could be connected.
That's the way to do it. Half the battle is just ruling things out one at a time. @mossy_compass let us know what you find.
Did you ever get to the bottom of this? I'm curious now. These electrical gremlins make a change from tyre pressure questions.
Not yet,weather's been grim so haven't got the multimeter out. Should have a dry afternoon on Friday though. Will update when I know more.
While youre in there, check the grounds. On the Agility the ground point is under the front panel and it's notorious for corroding. A wire brush and some contact grease will save you grief later.
Post a reply
Trending Discussions
- I have learned to distribute heavier items rather than putting everything in one basket 9 replies
- What should I do if a seller refuses to refund a cancelled order? 8 replies
- The connector pins were corroded after years of outdoor use 11 replies
- A trip around the botanical gardens would be lovely 11 replies
- Does anyone use a wall-mounted shelf for their scooter charger? 8 replies