A different seat position would solve several fit problems
I've had my scooter for about a year now and the seat just never feels right. It's too far back so I end up slouching to reach the tiller, and my legs don't sit flat. I've tried adjusting the tiller angle and adding a cushion but it only helps a little. Has anyone moved the seat itself forward or changed the mounting position? I'm not very handy but I'm willing to try if it's not too involved. I mostly use it for shopping and getting to the park, nothing heavy.
Moving the seat forward is doable on a lot of models but it depends on the seat post and the base plate. Some have slotted holes so you can shift it an inch or two. What scooter do you have?
I had the same slouching problem. For me it wasn't the seat position, it was the seat height. Raising it a bit let me sit more upright and reach the tiller without leaning. Worth checking before you start drilling anything.
On mine the seat slides on a track and there's a bolt underneath. i loosened it and moved it forward maybe two inches, then tightened it back up. Took ten minutes. But you have to check that the seat doesn't hit the rear cover when it swivels.
Good point about tthe swivel. Also if you move it too far forward the center of gravity changes and it can feel tippy on slopes. I'd keep it modest.
This might be a silly question but is the seat post itself adjustable in height on your scooter? Mine has a pin you pull and it clicks into different holes. That changed my leg position a lot. I never toucehd the forward/back thing.
Not silly at all, that's often the firstt thing to try. But if the reach to the tiller is the main issue then height alone might not fix it. You could also look at a different seat with a deeper backrest or one that's shaped differently. Some of the aftermarket seats have a more forward cut.
I tried moving the seat on my old scooter and stripped one of the bolts because they were seized. Soak them in penetrating oil first if they haven't been touched in years. Otherwise it's straightforward.
Thanks for the tips. It's a secondhand Pride model, not sure of the exact name. I'll look for the bolt underneath and check if the holes are slotted before I do anything. The swivel clearance is something I hadn't thought about.
Post a reply
Trending Discussions
- Suspension vs none for back problems 9 replies
- Choosing equipment for a young adult starting university 9 replies
- A removable key is useful when several people share a home 15 replies
- Can a standing mobility scooter be used indoors as well as outdoors? 9 replies
- Can hotels arrange mobility scooter rentals for their guests? 14 replies